I read the thread from 3-27, however, i cannot for the life of me figure out how to get the f'in electrical connector sperated from the light housing assembly to pull it through the front. I already broke off where the connector is attached to the housing, i cannot get the two apart. Its the white or light gray connector. thank you

If you have the OEM Fog light Kit, it should be very simple, there should be a "tab-like" thing on the side of the connector, just use a screwdriver and try to release that tab, and in the same time try pulling the connector so it could be be released from the housing assembly...Good Luck..

Also use a bit of WD-40 before separating the connectors. Good luck.

If the tab was on the other side, you wouldn't have seen it - definitely check that out.